Din kurv er tom


Bas Arm On Tour
18/03 2019 kl. 14:03
I weekenden tog vi hul på Bas Arm On Tour i Ridehuset, ...
2 x elever på skole
11/03 2019 kl. 11:38
Både Oliver og Andreas er på skole lige nu: Andreas ...
Her går det godt! Solen skinner: Vi undlader at tænke ...

d&b D6. NL4 & EP5

250 DKK

(ex. moms)

Vejledende pris: 250 DKK
Leje pr. døgn.
På lager
Varenr.: 24
Vægt 8,00 kg.

d&b D6. NL4 & EP5

Både NL4 og EP5 speaker output.

D6 amplifier

The d&b D6 amplifier is a dual channel amplifier incorporating digital signal processors (DSP) to provide loudspeaker specific configurations and functions. It is designed for use with d&b loudspeakers except the 2-Way Active mode, the V-Series and the B2-SUB configurations, has both digital and analog signal inputs as well as link outputs, remote control and monitoring capabilities and sophisticated protection circuits. It utilizes a switch mode power supply with PFC suitable for mains supply voltages 100 V / 115 V / 200 V / 230 V, 50 – 60 Hz and has a temperature and signal controlled fan to cool the internal assemblies. It is specifically designed to deliver medium power into low impedance loads between 4 and 16 ohms. A user definable 4-band parametric equalizer and signal delay capability of up to 340 ms are incorporated and can be applied independently to each channel. A signal generator offering pink noise or sine wave program is also incorporated. The D6 uses its Load monitoring and System check functions to ascertain the status of the loudspeaker impedance. d&b System check verifies that the system performs within a predefined condition, whilst d&b Load monitoring enables an automatic and continuous impedance monitoring. Both can determine the status of an LF or HF driver in systems with multiple elements, even if these are crossed over passively. All of these functions and parameters can be easily accessed and controlled via the LCD in conjunction with the digital rotary encoder or through the d&b Remote network.


D6 data (linear setting with subsonic filter)  
Rated output power (THD+N < 0.1%) 2 x 350 W into 8 Ω, both channels are driven
2 x 600 W into 4 Ω, both channels are driven
S/N ratio (unweighted, RMS) > 110 dBr

D6 Connectors
INPUT/LINK ANALOG A/B 3 pin XLR female/male
Sampling rate 48 kHz / 96 kHz
REMOTE 2 x RJ 45 parallel

D6 Digital Signal Processing
Sampling rate 96 kHz / 27 Bit ADC / 24 Bit DAC
Basic delay / latency analog input 0.3 ms

D6 Power supply
Autosensing switch mode power supply for 100/115/200/230V, 50 - 60 Hz
Mains connector PowerCon®

D6 Remote network
Remote network CAN-Bus

D6 Dimensions, weight
Height x width x depth 2 RU x 19" x 353 mm / 13.9"
Weight 8 kg / 17.6 lb


Login Bruger

Husk log ind

Nyhedstilmelding (e-mail)

Spam tjek * (Indtast teksten der vises i billedet nedenfor.)

Tilmeld Afmeld